Savin 2513f Instructions d'exploitation télécharger pdf (Page 93)

Remote Maintenance by telnet

SLP

Use this command to configure SLP settings.

You can search the NetWare server using SLP in the PureIP environment of

NetWare5. To use the slp command, you can configure the value of TTL which

can be used by the SLP multi-cast-packet.

Note

❒ The default value of TTL is “1”. A search is executed only within a local seg-

ment. If the router does not support multi-cast, the settings are not available

even if the TTL value is increased.

❒ The acceptable TTL value is 1 - 255.

msh> slp ttl {1 - 255}

Changing the password

Use the passwd command to change the remote maintenance password.

Important

❒ Be sure not to forget or lose the password.

Note

❒ The default password is “password”.

Type “passwd”.

msh> passwd

Type the current password.

Old password:

Type the new password.

New password:

Note

❒ The password must consist of 3 to 8 alphanumeric characters and symbols.

Upper and lower case characters are considered unique. For example, R is

different from r.

❒ The password is the same as that used in the configuration of the Network

Interface Board using a Web Browser and that used in the NIB Setup Tool.

If you change a password from telnet, the other passwords are also

changed.

Type the new password once again.

Retype new password:

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 111 112

Pas de commentaire

Savin 2513f Instructions d'exploitation Page 93