Savin 2513f Instructions d'exploitation télécharger pdf (Page 30)

Windows 2000 Configuration

Make sure that the“Internet Protocol (TCP/IP)” is selected in the [Compo-

nents checked are used by this connection:] box on the [General] tab.

Note

❒ Select the TCP/IP protocol box if it is not already selected.

❒ If the TCP/IP protocol is not installed, click [Install] on the [General] tab to

install it. For more information about installing the TCP/IP protocol, see

Windows 2000 Help.

Configure the TCP/IP protocol with the appropriate IP address, subnet

mask and other settings.

Check with the network administrator that the settings are correct.

Configuring NetBEUI for Printing

Follow these instructions to configure the Network Interface Board and Win-

dows 2000 to use the NetBEUI protocol.

Configuring the machine

Configure the machine to use the NetBEUI protocol.

• Make sure that the NetBEUI protocol is set to active. (The default is active.)

Reference

For more information about how to make the above settings, see the System

Settings.

Configuring a Windows 2000 computer

Follow these steps to configure a Windows 2000 computer to use the NetBEUI

protocol.

Click [Start] on the taskbar, point to [Settings], and then click [Network and

Dial-up Connections].

Click [Local Area Connection]. On the [General] tab, click [Properties].

Make sure that the“NetBEUI Protocol” is selected in the [Components

checked are used by this connection:] box on the [General] tab.

Note

❒ Select the NetBEUI protocol box if it is not already selected.

❒ If the NetBEUI protocol is not installed, click [Install] on the [General] tab

and install it. For more information about installing the NetBEUI protocol,

see Windows 2000 Help.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 111 112

Pas de commentaire

Savin 2513f Instructions d'exploitation Page 30