Savin 2513f Instructions d'exploitation télécharger pdf (Page 43)

Configuring the Protocols

Configuring TCP/IP and IPP for Printing

These instructions are for configuring the Network Interface Board and Win-

dows NT to use the TCP/IP protocol and IPP.

Configuring the machine

Configure the machine to use the TCP/IP protocol.

• Make sure that the TCP/IP protocol is set to active. (The default is active.)

• Assign an IP address and make other settings required for using the TCP/IP

protocol.

Reference

For more information about how to make the above settings, see the System

Settings.

If DHCP is used to assign IP addresses, see P.90 “When Using DHCP”.

Note

❒ After setting the IP address, use the ping command to make sure that it has

been correctly set.

Click [Start], point to [Programs], and then click [Command Prompt].

Type the following: (Example IP address is 192.168.15.16)

C:\> ping 192.168.15.16

If the address has been configured correctly, the following message ap-

pears.

Reply from 192.168.15.16 : bytes=32 time<10ms TTL=32

If the address has been configured incorrectly, the following message ap-

pears.

Request timed out.

Configuring a Windows NT computer

These steps are for configuring a Windows NT computer to use the TCP/IP pro-

tocol.

Open [Control Panel] and double-click the [Network] icon. Make sure that

“TCP/IP Protocol” is listed in the [Network protocols] box on the [Protocols]

tab.

Note

❒ If the TCP/IP protocol is not installed, click [Add] on the [Protocols] tab to

install it. For more information about installing the TCP/IP protocol, see

Windows NT Help.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 111 112

Pas de commentaire

Savin 2513f Instructions d'exploitation Page 43