Savin 2513f Instructions d'exploitation télécharger pdf (Page 85)

Remote Maintenance by telnet

Note

❒ If the “Cannot write NVRAM information” message appears, the changes

are not saved. Repeat the steps above.

❒ The Network Interface Board is reset automatically when the settings are

changed.

❒ When the Network Interface Board is reset, the active print job which has

already been sent to the machine will finish printing. However, jobs that

have not been sent yet will be canceled.

Commands List

This is a list of commands that can be used via remote maintenance.

Note

❒ Type “help” to see a list of commands that can be used.

msh> help

❒ Type “help command_name” to display information about the syntax of that

command.

msh> help command_name

TCP/IP address

Use the ifconfig command to configure TCP/IP(IP address, subnet mask, broad-

cast address, default gateway address) for the machine.

❖

❖❖

❖ Reference

msh> ifconfig

❖

❖❖

❖ Configuration

msh> ifconfig naf0 parameter address

The following is an example for configuring an IP address of 192.168.15.16.

msh> ifconfig naf0 192.168.15.16

The following is an example for configuring a subnet mask of 255.255.255.0.

msh> ifconfig naf0 netmask 255.255.255.0

Parameter Meaning

(no parameter) IP address

netmask subnet mask

gateway default gateway address

broadcast broadcast address

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 111 112

Pas de commentaire

Savin 2513f Instructions d'exploitation Page 85