72. Plug in the power cord and turn on the main switch.
73. A166 copier only:
Select the paper size for the 1st tray by sliding the paper size slider [A].
Load paper (A4/8
1/2
" X11" sideways or A3/8
1/2
" X11" lengthwise).
74. When a paper tray unit is to be installed:
(1) Install the paper tray unit as per the unit’s installation procedure.
(2) Load paper (A4/8
1/2
" X11" sideways or A3/8
1/2
" X11" lengthwise; one
of these paper sizes has to be used for the Auto Color Calibration
procedure).
(3) Enter UP3-3 as follows.
→ → → → →
NOTE: Hold down the Clear/Stop key for more than 3 seconds.
(4) Select the tray (1 to 4).
(5) Select the paper direction (sideways or lengthwise).
(6) Select either the 1: "Common" or 2: "Special" groupings.
(7) Select the appropriate paper size.
(8) Set the paper size for each tray installed.
75. Perform the "Developer Agitation for All Colors," as per the flow chart
on the following page.
[A]
Installation
Procedure
COPIER INSTALLATION
SM 3-31 A166/A187/A189
Commentaires sur ces manuels