Savin SDC103A Manuel de service télécharger pdf (Page 274)

100

101

17. Adjust the angle [A] of the mirror unit as follows:

1) Turn on the copier main switch and wait for the ready condition.

2) Open the lens cover and position the mirror unit on the exposure glass.

3) Set the correction filter [B] (for positive film) in the filter slot.

4) Turn on the projector main switch and press the option key.

5) Perform shading using the positive 35 mm slides mode.

6) Put one of the orange base films in the slide holder and position it in

the projector unit.

7) Make a copy of the orange film.

8) Ensure that the orange image is even. If the image is uneven, adjust

the mirror angle as follows:

8-1) When the leading part of the image is dark (as shown in [C]).

a) Move the front and rear arm guides [D] to the left so that the

mirror angle is increased (2 screws each).

NOTE: Position the arm guides in the same location

at the front and rear, using the ruled marks.

(refer to the illustration above). This prevents the

mirror from being twisted.

b) Make a copy of the orange film.

c) Repeat steps a) and b) until the orange image is even.

[A]

[B]

[C]

[D]

Installation

Procedure

FILM PROJECTOR UNIT (A718) INSTALLATION

SM 3-59 A166/A187/A189

CÓPIA NÃO CONTROLADA

1 2 ... 269 270 271 272 273 274 275 276 277 278 279 ... 622 623

Commentaires sur ces manuels

Pas de commentaire

Savin SDC103A Manuel de service Page 274

Commentaires sur ces manuels

Produits connexes et manuels pour Multifonctionnels Savin SDC103A