Savin SDC103A Manuel de service télécharger pdf (Page 159)

100

101

For Green, copying takes longer than for red or blue. This is because the

revolver has to rotate 180 degrees to move the second color into position.

Toner is likely to cross over to the drum when development roller gears are

meshing and unmeshing during revolver rotation. (See sections 6.2.5: Drive

Mechanism, and 6.2.6: Development Bias.) So, the revolver must rotate so

that the areas of the drum that touch the revolver during that time will arrive

at a non-image area on the transfer belt. Because of this, the 180-degree

rotation is divided into two steps, and the transfer belt has to make an extra

turn.

The same happens if the image area is longer than A4/Letter sideways. The

non-image area on the drum is too short for the revolver to turn the next

color into position within the same transfer belt rotation, so the belt has to

make an extra turn to allow the revolver to rotate. This is true for R, G, or B.

(So larger than A4/Letter sideways for Green requires two extra turns of the

belt.)

(This situation will be dealt with in more detail in the "Transfer Belt Unit"

section.)

Between copies of a multi-copy job, the revolver must turn 270 degrees.

After a copy job, the development unit is sent back to the first color

development position. Then, the machine performs the revolver H.P. process

and stops.

CPM

A4/Letter sideways

More than

A4/Letter sideways

32.5

DEVELOPMENT UNIT

A166/A187/A189 2-90 SM

CÓPIA NÃO CONTROLADA

1 2 ... 154 155 156 157 158 159 160 161 162 163 164 ... 622 623

Commentaires sur ces manuels

Pas de commentaire

Savin SDC103A Manuel de service Page 159

Commentaires sur ces manuels

Produits connexes et manuels pour Multifonctionnels Savin SDC103A