Savin SDC103 Manuel d'instructions télécharger pdf (Page 2)

SDC-103 Automatic Screwdriver Controller (ICOM) Instruction Manual

 2006 Ameritron 1

Introduction (A)

Controller with six wires.

The SDC-103 Screwdriver Antenna Controller will automatically adjust the

resonant frequency of a screwdriver antenna. The controller reads the CI-V

frequency data from a compatible ICOM radio. The controller then adjusts the

resonant frequency of the antenna. Three pre-selected antenna positions can also

be stored by the SDC-103. An antenna sensor is required for the counter and

automatic operation to function properly. This controller is compatible with

single and dual sensor antenna setups. If your antenna does not have a sensor

installed, contact the antenna manufacturer or MFJ.

Features

• Automatic Antenna Tuning when connected to an ICOM radio

• 3 Programmable Presets

• Manual UP/DN buttons

• Current Sensor Trip for Antenna/Motor Protection

• Auto-Park: Lowers antenna to lowest position and zeros counter

• Powered From 12V Vehicle Supply

• Power: Push button switch powers the controller on and off.

• Up: Moves the screwdriver antenna up.

• Down: Moves the screwdriver antenna down.

• Setup: Top bank of preset buttons.

• Skip: Bottom bank of preset buttons.

•

Enter: Bottom bank of preset buttons.

1 2 3 4 5 6 7 ... 12 13

Pas de commentaire

Savin SDC103 Manuel d'instructions Page 2